2006 - 2010 Chevrolet, Buick, GMC, Cadillac Vehicles Remote Programming Instructions (Select Models)

2006-2010 Buick Lucerne, 2008-2009 Cadillac CTS, 2006-2007 Chevrolet Monte Carlo, 2008-2010 Chevrolet Silverado, 2007-2010 Chevrolet Tahoe, 2008-2010 GMC Sierra

Use this Procedure for Vehicles with Driver Information Center Buttons

NOTE: This information is also in your owner's Manual in the Driver's Information Center Section.

1. Insert Key and turn to ON position so you can access Driver Information Center
2. Press the vehicle information button until PRESS TO RELEARN REMOTE KEY displays
3. Press the set/reset button until REMOTE KEY LEARNING ACTIVE displays
4. Press and hold the lock and unlock buttons on the first remote at the same time for approximately 15 seconds. A chime will sound indicating that the remote is programmed.
5. To program additional remotes at this time repeat step 3. This vehicle can have a maximum of eight remotes programmed.
6. To exit Programming mode turn key off and remove key. Test remote(s).

Use this Procedure for Vehicles without Drivers Information Center Buttons

1. To access this display, the vehicle must be in Park (P) with key in the on position (as far as you can go without cranking engine)
2. Press the trip odometer reset stem until RELEARN REMOTE KEY displays.
3. Press and hold the trip odometer reset stem for three seconds. The message REMOTE KEY LEARNING ACTIVE will display
4. Press and hold the lock and unlock buttons on the first remote at the same time for approximately 15 seconds. A chime will sound indicating that the remote is programmed.
5. To program additional remotes at this time repeat step 3. This vehicle can have a maximum of eight remotes programmed.
6. To exit Programming mode turn key off and remove key. Test remote(s).