1998 - 2002 Honda Passport Remote Programming Instructions

NOTE: Some Passports require you to turn ignition on and off 5 times in step 5.

1. Open the driver's door.
2. Insert the key into ignition.
3. Turn the ignition switch to the ACC position and then to the LOCK position three times. (This step must be completed within 3 seconds -- go as fast as you can, or the system will not enter the Programming mode.)
4. Within 10 seconds, close and open the door two times.
5. Turn the ignition switch to the ACC position and then to the LOCK position three times (again, do this within 3 seconds.)
6. Within 10 seconds, close and open the door. Verify that the power door locks cycle once to confirm that the system is in Programming mode.
7. Within 20 seconds, press the LOCK button on the remote you are Programming. Verify that the door locks cycle once.
8. Within 20 seconds, press the UNLOCK button on the remote.
9. Verify that the door locks cycle once to confirm that the system has accepted the remote's code.
10. Repeat steps 7 and 8 for each remote to be added.
11. Remove the key from the ignition.