Key & Remote Programming Instructions
      Back to home
      1. Help Center
      2. Remote Programming Instructions
      3. Key & Remote Programming Instructions

      2007 - 2008 Mitsubishi Eclipse Remote Programming Instructions

      NOTE: This procedure does NOT program the key portion of the Key-Remote Combo. It only programs the remote portion.

      1. Locate the Data Port under the driver's side dashboard usually located to the right of the steering column.
      2. Insert keys in ignition and leave in the OFF position.
      3. Make sure there are metal contact pins in terminals 1 and 4 and connect the Data Port terminals 1 and 4 with a suitable jumper wire, leave the jumper wire connected throughout the programming. mceclip0.png
      4. Within 10 seconds after connecting the jumper wire, press the Hazard Switch 6 times. Note: The doors will automatically lock and unlock once at this time indicating that the system is in the Programming mode.
      5. Press the LOCK button on the remote to be registered three times within 10 seconds. Upon successful Programming, the door will lock and unlock once.
      6. Repeat step 5 with up to 4 remotes (including any existing remotes) within one minute. After completing each Programming, the doors will lock and unlock once.
      7. Disconnect the Programming wire and remove the keys from the ignition.