Key & Remote Programming Instructions
      Back to home
      1. Help Center
      2. Remote Programming Instructions
      3. Key & Remote Programming Instructions

      2007 Chevy Silverado Remote Programming Instructions

      Instructions for 2007 Chevrolet Silverado with the Old Body Style

      1. Close all vehicle doors.
      2. Insert the key into the ignition.
      3. Hold down the power UNLOCK button on the driver's door panel continue to hold down until instructed to release in step 9.
      4. Perform steps 5 through 8 in fairly rapid succession.
      5. Turn the ignition switch to the ON position (as far as you can go without starting the engine).
      6. Turn the ignition switch to the OFF position.
      7. Turn the ignition switch to the ON position.
      8. Turn the ignition switch to the OFF position.
      9. Release the power unlock button on the door panel. The vehicle will lock and unlock the doors automatically.
      10. Hold down the LOCK and UNLOCK buttons on the remote simultaneously until the door locks and unlocks. This step may take up to 30 seconds.
      11. Repeat step 10 NOW for each additional remote (including any existing remotes).
      12. Turn the ignition switch to the ON position in order to exit the remote Programming mode.

      Instructions for 2007 Chevrolet Silverado with the New Body Style

      NOTE: Use this Procedure for Vehicles with Driver Information Center Buttons This information is also in your owner's Manual in the Drivers Information Center Section.

      1. Insert Key and turn to ON position so you can access Driver Information Center
      2. Press the vehicle information button until PRESS TO RELEARN REMOTE KEY displays
      3. Press the set/reset button until REMOTE KEY LEARNING ACTIVE displays
      4. Press and hold the lock and unlock buttons on the keyless remote at the same time for approximately 15 seconds. A chime will sound indicating that the remote is programmed.
      5. To program additional remotes at this time repeat step 4. This vehicle can have a maximum of eight remotes programed
      6. To exit Programming mode turn key off and remove key. Test remote(s).
      7. Use this Procedure for Vehicles without Drivers Information Center Buttons
      8. To access this display, the vehicle must be in Park (P) with key in the on position (as far as you can go without cranking engine)
      9. Press the trip odometer reset stem until RELEARN REMOTE KEY displays.
      10. Press and hold the trip odometer reset stem for three seconds. The message REMOTE KEY LEARNING ACTIVE will display
      11. Press and hold the lock and unlock buttons on the first keyless remote at the same time for approximately 15 seconds. A chime will sound indicating that the remote is programmed.
      12. To program additional remotes at this time repeat step 3. This vehicle can have a maximum of eight remotes programmed.
      13. To exit Programming mode turn key off and remove key. Test remote(s).