2004 - 2010 Honda Odyssey Remote Programming Instructions

NOTE: Instructions have timing requirements. Waiting too long between steps may result in your vehicle’s computer timing out, requiring you to start over. Once you begin the pairing procedure, be sure to move at a quick and even pace.

1. Make sure the doors are unlocked.
2. Turn the ignition to the ON position (II)
3. Press the LOCK or UNLOCK button on the remote.
4. Turn the ignition to OFF (0).
5. Turn the ignition to ON (II).
6. Press the LOCK or UNLOCK button on same remote.
7. Turn the ignition to OFF (0).
8. Turn the ignition to ON (II).
9. Press the LOCK or UNLOCK button on the same remote.
10. Turn the ignition to OFF (0).
11. Turn the ignition to ON (II).
12. Press the LOCK or UNLOCK button on the same remote. Make sure the door locks cycle to indicate that the system has entered pairing mode.
13. Press the LOCK button on each remote that you want paired. Make sure the door locks cycle each time to indicate that the remote has been accepted. The system will accept up to three remotes
14. Turn the ignition to OFF (0) to exit the pairing remote.