2007 GMC Sierra Remote Programming Instructions

Procedure for Old Body Style

1. Close all doors
2. Insert key into ignition
3. Hold down the power UNLOCK button on the driver's door panel, continue to hold down until instructed to release in step 9.
4. Perform steps 5 through 8 in a fairly rapid succession.
5. Turn the ignition to the ON position (as far as you can go without starting the engine.)
6. Turn the ignition to the OFF position.
7. Turn the ignition to the ON position (as far as you can go without starting the engine.)
8. Turn the ignition to the OFF position.
9. Release the power UNLOCK button on the door panel. The vehicle should respond by the door locks locking and unlocking automatically. (If locks do not cycle after you let go, then the vehicle has not entered Programming mode and you must start the procedure over. Remove the key from the ignition, open the driver's door and return to step 1). If the locks do cycle automatically then proceed to step 10.
10. Hold down the LOCK and UNLOCK buttons on the remote until the doors lock and unlock. This may take up to 30 seconds.
11. Repeat step 10 NOW for each additional remote. (Including any existing remotes).
12. Turn the ignition to the ON position to exit the Programming mode.
13. Test remote(s).

Procedure for New Body Style

Use this Procedure for Vehicles with Driver Information Center Buttons This information is in your owner's Manual in the Drivers Information Center Section.

1. Insert Key and turn to ON position so you can access Driver Information Center
2. Press the vehicle information button until PRESS TO RELEARN REMOTE KEY displays
3. Press the set/reset button until REMOTE KEY LEARNING ACTIVE displays
4. Press and hold the lock and unlock buttons on the keyless remote at the same time for approximately 15 seconds. A chime will sound indicating that the remote is programed. 5. To program additional remotes at this time repeat step 4. This vehicle can have a maximum of eight remotes programmed 6. To exit Programming mode turn key off and remove key. Test remote(s).

Use this Procedure for Vehicles without Drivers Information Center Buttons. To access this display, the vehicle must be in Park (P) with key in the on position (as far as you can go without cranking engine)

1. Press the trip odometer reset stem until RELEARN REMOTE KEY displays.
2. Press and hold the trip odometer reset stem for three seconds. The message REMOTE KEY LEARNING ACTIVE will display
3. Press and hold the lock and unlock buttons on the first keyless remote at the same time for approximately 15 seconds. A chime will sound indicating that the remote is programmed.
4. To program additional remotes at this time repeat step 3. This vehicle can have a maximum of eight remotes programmed.
5. To exit Programming mode turn key off and remove key. Test remote(s).