1994 - 1995 Chevrolet Camaro Remote Programming Instructions

NOTE: When you begin the programming sequence to program your remote to your installed remote entry system, you must have all the remotes (including previously programmed remotes) with you at the time of programming. All previously programmed remotes will be erased at this time. 

1. Access the data link Connector. (Located next to steering column)
2. Using fused jumper wire (you can jump connectors using a thin wire such as a paperclip if you are unsure please go to your local automotive service center).  Jump connectors G & A in data link connector. (DLC)
3. Doors will lock & unlock indicating programming mode active.
4. To program remotes proceed by pressing any button on the remote -- just one time (doors will lock & unlock to confirm remote is programmed.)
5. Repeat above procedure (step 4) for any other remotes.
6. Remove fused jumper wire to exit programming mode.