2008 - 2009 Chrysler Town and Country, 2008 - 2009 Dodge Grand Caravan Remote Key Fobik Programming Instructions

NOTE: The Remote Keyless Entry (RKE) remote and key will  be programmed during this procedure. Repeat this procedure to program up to 8 keys. If you do not have a programmed RKE remote with an integrated key, contact your authorized dealer for details. If you have lost both or only have one valid RKE fobik, you must contact or visit your local authorized dealer for programming information. Once you have programmed the new RKE fobik to your vehicle, it cannot be reprogrammed to another vehicle in the future. If you have two valid remote RKE fobiks, you can program new RKE remotes to the system by performing the following procedure:

1. Insert the first valid key fobik into the ignition switch and turn the ignition switch to the on position for at least three seconds but no longer than 15 seconds.
2. Turn the ignition switch to the lock/off position and remove the first key.
3. Insert the second valid key fobik and turn the ignition switch to the on position within 15 seconds. After 10 seconds, a chime may sound and the Vehicle Security Light will begin to flash.
4. Turn the ignition switch to the lock/off position and remove the second key.
5. Insert the new key fobik into the ignition switch, and turn the ignition switch to the on position within 60 seconds. After 10 seconds, a single chime will sound, and the vehicle security light will stop flashing.
6. Turn on again for three seconds, and then turn off. The new key fobik is programmed.