2000 - 2005 Chevrolet Impala, 2000 - 2005 Chevrolet Monte Carlo Remote Programming Instructions

1. Turn the ignition to ACC or on and the radio to off. Do not crank the engine.
2. Press and hold the display button on the radio for at least five seconds until settings is displayed.
3. Press the seek up or down arrows until fob program appears on the display. Press the previous or next button to enter the submenu.
4. The current selection will have an asterisk next to it. Begin will be displayed. Press the display button to start programming.
5. When the message push fob flashes, press and hold the lock and unlock buttons on the first remote at the same time for 15 seconds. A chime will be heard to verify the remote is learned.
6. Repeat step 5 for each additional remote up to four remotes total.
7. You do not need to press the display button again, just press down the lock and unlock buttons on the next remote to be learned to a maximum of four remotes per vehicle. The mode you selected is now set. You can either exit the Programming mode by following the instructions later in this section or program the next feature available on your vehicle.
8. Exit (Exit Feature Customization Mode): This feature allows you to exit the vehicle customization programming. To exit: Scroll until exit appears on the display. Press the display button to exit programming. A chime will he heard to verify the exit.