Key & Remote Programming Instructions
      Back to home
      1. Help Center
      2. Remote Programming Instructions
      3. Key & Remote Programming Instructions

      2010 - 2012 Mazda MAZDA3 Remote Programming Instructions

      Mazda 3 without Smart Entry System

      1. Remove key from ignition
      2. Close all doors.
      3. Open the driver's door.
      4. Perform following steps within 24 seconds. Turn ignition switch ON and back to LOCK position three times
      5. Close and open driver's door three times
      6. Door locks should lock and unlock automatically, if they do not wait 40 seconds and repeat the procedure starting at step 1.
      7. Press the UNLOCK button of each keyless remote to be programmed twice, door locks should lock and unlock after each remote is programmed.
      8. If door locks do not lock and unlock proceed as follows. Close and open the driver's door once, the door should lock and unlock twice. If door locks do not lock and unlock, start the procedure over with Step 3.
      9. Exit vehicle and test remote(s)