2008 Toyota Yaris Remote Programming Instructions

NOTE: These instructions are for the remote portion of the Key/Remote combo only. The key portion will still need to be cut and programmed if it requires a transponder chip.

1. Drivers door open & unlocked. Key out of ignition.
2. Insert & remove key 2 times within 5 seconds.
3. Close & open driver's door twice within 40 seconds.
4. Insert key into ignition & remove.
5. Close & open driver's door twice within 40 seconds.
6. Insert key into ignition.
7. Close the door.
8. Turn the ignition switch from "LOCK" to "ON" & back to "LOCK" (ONCE for ADD mode/TWICE for REWRITE mode).
9. Remove the key from ignition.
10. To confirm your mode selection, the power locks will now cycle "lock" to "unlock" a number of times corresponding to your key cycles in step 8.
11. Within 40 seconds of confirmation, press both remote Lock & Unlock buttons simultaneously. Within 3 seconds press the remote Lock button for more than 1 second. If successful, the power locks will cycle once (twice indicates remote problems). Repeat step 11 for additional remotes.
12. Open door to exit Programming.