1993 - 2015 Nissan Vehicles Remote Programming Instructions (Select Models: See Attached List)

NOTE: Verify your vehicle's year, make, and model are on the attached list before attempting these programming steps.

NOTE: Before entering programming mode, have in your possession all of the remotes you will be using on the vehicle. Once you program the remote, all previous codes will be erased from the memory. The other remotes will not be functional until you program the remotes again.

1. Close and lock all doors with the driver's side power lock/unlock switch.
2. Insert key into ignition and remove it from the ignition key cylinder at least six times within 10 seconds. Your hazard lamps will flash if you have performed this step successfully. Note: Withdraw key completely from ignition cylinder each time. If this procedure is performed too fast, the system will not enter programming mode.
3. Insert key into the ignition cylinder and turn to the ACC position.
4. Within 5 seconds, push any button on the remote remote. Your hazard lamps should flash.
5. Note: Do not press the button more than one time in the above step. If the button is pressed more than one time, the programming procedure will not be successful.
6. If there are any remaining remotes (including the old ones), unlock then lock all doors using the driver's side power lock/unlock switch and within 5 seconds, push any button on the next remote. Your hazard lamps should flash. Repeat this step for each remote (including any existing remotes).
7. Turn the key to the off position, remove keys from the ignition, unlock doors using the driver's side power lock/unlock switch then open the driver's side door
   
   1993 - 2015 Nissan Vehicles Remote Programming