2004 - 2007 Chrysler Town and Country Remote Programming Instructions

NOTE: You must have your key cut on the remote by a qualified locksmith or your dealership before attempting these programming instructions.

1. Insert the first working key into the ignition.
2. Turn the ignition to the on position for at least three seconds but no longer than fifteen seconds.
3. Turn the Ignition to the off position and remove the first remote head key.
4. Insert the second working remote head key into the Ignition.
5. Turn the Ignition to the on position for at least three seconds but no longer than fifteen seconds.
6. After ten seconds a chime will sound and the vehicle's security light will begin to flash.
7. Turn the ignition to the lock position and remove the second remote head key.
8. Insert the new remote head key into the ignition.
9. Turn the ignition to the on position within 60 seconds.
10. After ten seconds a single chime will sound and the vehicle's security light will stop flashing.
11. The vehicle's security light will turn on again for three seconds and off to indicate successful programming.
12. Test all remotes.