Instructions for models: 2001 - 2005 Dodge Stratus Coupe, 2004 Chrysler Sebring 2DR Coupe, 1996-1999 Mitsubishi 3000GT, 1999-2004 Mitsubishi Diamante, 1996-2006 Mitsubishi Eclipse, 2004-2006 Mitsubishi Endeavor, 1995-1996 Mitsubishi Expo, 1999-2006 Mitsubishi Galant, 2002-2006 Mitsubishi Lancer, 2000-2006 Mitsubishi Montero, 2003-2006 Mitsubishi Outlander
- Locate the Data Port/OBD2 Port. (Most commonly located on driver's side under steering column)
- Insert the key into the ignition and leave in the off position.
- Make sure there are metal contact pins in terminals 1 and 4 and connect the Data Port with a suitable jumper wire, leave jumper wire connected throughout the programming procedure. Make sure you know which terminals are 1 and 4.
- Within 10 seconds after connecting the jumper wire, turn the ignition switch to the ACC position and then back to off. Note: The doors will automatically lock and unlock once at this time indicating that the system is in the programming mode.
- Press the lock button on the remote to be registered three times within 10 seconds. Upon successful programming, the door will lock and unlock once.
- If there are two remotes, register the first, then register the second.
- Repeat step 5 within one minute to program second remote.
- After completing the second programming, the doors will lock and unlock once.
- Disconnect the programming wire and remove the keys from the ignition.