(NOTE: See attached list to verify your vehicle uses these programming instructions. A maximum of two keyless remotes can be programed.)
-
Insert key in ignition and leave in the off position Locate the Data Link Port. It is located under dash driver's side.
-
Make sure there are metal contact pins in terminals 8 and 4.
-
Be sure you know which pins are 8 and 4
(NOTE: Your OBDII port will not have numbers, use this diagram.)
-
Connect 8 to 4 with a suitable jumper wire (leave the jumper wire connected throughout the programming procedure).
-
Close doors.
-
Turn ignition to the on position (as far as you can go without cranking the engine).
-
Doors will lock.
-
Press and hold both the lock and unlock buttons together on the first remote to be programed.
-
After about 15 seconds, the vehicle will respond by locking and unlocking the doors.
-
Release the buttons on the remote.
-
Within one minute, repeat the previous step on the remaining remotes to be programed.
-
Remove jumper wire applied to the OBDII port