Verify your model vehicle is on the attached list before attempting these programming instructions.
Close and lock all doors with the driver's side power lock/unlock switch.
- Insert key into ignition and remove it from the ignition key cylinder at least six times within 10 seconds. NOTE: Withdraw key completely from ignition cylinder each time. If this procedure is performed too fast, system will not enter programming mode.
- Your hazard lamps will flash if you have performed this step successfully.
- Insert key into the ignition cylinder and turn to the ACC position.
- Within 5 seconds, push any button on the remote. Note: Do not press the button more than one time in the above step. If the button is pressed more than one time, the programming procedure will not be successful.
- Your hazard lamps should flash.
- If there are any remaining remotes (including the old ones), unlock then lock all doors using the driver's side power lock switch and within 5 seconds, push any button on the next remote.
- Your hazard lamps should flash.
- Repeat this step for each remote (including any existing remotes).
- Turn the key to the off position, remove keys from the ignition.
- Unlock the doors using the driver's side power unlock/lock switch and open the driver side door.