1997 - 1999 Chevrolet, Buick, Oldsmobile, & Pontiac Remote Programming Instructions (Select Models)

Instructions for Models: 1997-1998 Buick Skylark, 1997-1999 Chevrolet Cavalier, 1997-1998 Oldsmobile Achieva, 1997-1999 Pontiac Sunfire

NOTE: All Remotes for vehicle must be present at time of programming and re-programmed to the vehicle at the same time as the new remote(s).

1. Make sure ignition is in the off position.
2. Locate the programming connector in the trunk (driver's side). It is a plastic connector with two wires leading up to it. The connector is not plugged into anything. You may have to pull back trim to access the connector.
3. The programming connector should have two terminals.
4. Connect both terminals with a suitable jumper wire. Make sure the terminals remain connected throughout the programming procedure.
5. Press the lock and unlock buttons on the remote simultaneously.
6. In response the Keyless Entry Module will cycle all the door locks at once.
7. Your new remote has been accepted and all existing remotes have been erased.
8. Repeat the previous step for each additional remotes (including any existing remotes).
9. Do not remove jumper wire in between Programming of remotes.
10. Lastly, remove the jumper wire from the Keyless Remote Connector. Test remote(s)