1996 Dodge Ram Pick-Up Truck Remote Programming Instructions

1. Locate the keyless entry program line - a dark green wire with a molded plastic insulator on the end. The program line is located under the left side of the instrument panel. The wire is taped back to the harness (left of the steering column near the floor) and terminated with a black rubber mold.
2. Connect the program line from the Remote Keyless Entry Module to ground with a suitable jumper wire.
3. Insert the key into the ignition and turn ignition switch to the ON position.
4. Press any button on the remote to set code.
5. If there is a second remote, it has to be set at this time by pressing any button on the second remote.
6. The locks will lock and unlock automatically to confirm Programming.
7. Disconnect the program line from ground; turn ignition off, and remove key.